ENTERPRISE-WIDE RESOURCE MANAGEMENT (ERP) BEST PRACTICES Essay

ENTERPRISE-WIDE RESOURCE MANAGEMENT (ERP) BEST PRACTICES - Essay Example Hence, the essay intends to review and present the assessment of the Delphi study on Enterprise Resource Planning (ERP) towards assessing impact of ERP in the supply chain management (Akkermans et al., 2003). The review of the article propounded that ERP plays a vital role in the process of SCM of an organization. In the article, few prominent aspects regarding ERP in supply chain management are highlighted. The first aspect deals with the various problems that may arise in the near future, if enterprise resource planning gets implemented in the process of SCM. Accordingly, it has been postulated that the delivery of products gets integrated between suppliers and consumers in the process of supply chain. Thus, a need to enhance supply chain process is advocated due to the due to consistent change as per the requirements of the suppliers and customers. It has been argued that excess time is consumed in the supply chain process and inventory management. The second aspect is associated with the effectiveness of ERP in the enterprise-wide resource management. Accordingly, it has been determined that ERP not only deliver positive involvement in the four issues of the supply chain, but it also provides support towards the enhancement in customization of goods and services. In addition, the review of the article revealed that ERP leads towards increasing the level in the process of supply chain and information management. It also linked world-wide market through the support of IT systems and generates transparency of the market. At the same time, the review of the article rendered few major limitations of ERP implementation that may hinder the smooth functioning of supply chain process (Akkermans et al., 2003). The exploratory findings by European executives lead to the justification that implementing ERP in the supply chain management renders positive impact on the growth of an organization as well as it creates hindrances in terms of strategic businesses.

Internal Resistance of a Battery Lab Report Example | Topics and Well Written Essays - 250 words

Internal Resistance of a Battery - Lab Report Example The rheostat’s resistance is then varied a number of times, taking the current and voltage readings for each turn. The equation V = ÃŽ µ - Ir, is then used to determine the internal resistance of the battery, where V is the recorded total voltage drop across the battery, ÃŽ µ, the electromotive force or the total voltage put out by the battery, I the current flowing through the circuit and r the required internal resistance of the household battery. ÃŽ µ, V, and I, are measured and then the equation V = ÃŽ µ – Ir used to determine r which is then compared to accepted values. A possible limitation to this experiment that may lead to inaccurate results is the resistance of the connecting wires that is never taken to account. A new 9-volt battery was obtained and the voltage it could put out measured and recorded. Next, the slide on the rheostat was put to the extreme right—its maximum level--and its resistance measured and recorded. The circuit was then connected as shown in figure two below, keeping the switch open and taping its base to the table for stability (Internal Resistance of a Battery, p 2). The high current (20A) input of the ammeter was used, setting it up to the appropriate scale. Everything was now set for measurement taking. In quick moves, the switch was closed, both the voltage and current readings recorded and then the switch opened immediately. A few seconds were then to pass before the next measurements were taken (Internal Resistance of a Battery, p 2). The rheostat was the disconnected and its resistance decreased by sliding it a few centimetres to the left. This resistance was then measured and recorded. The circuit was then reconnected and the above procedure of taking measurements repeated. Next, the rheostat was disconnected and moved a few more centimetres to the left. As in the previous steps, the resistance was measured and recorded, the circuit reconnected and the current and voltage measurements repeated as